ENFORCER 295 - Alarm Control Panel*

Model Number: E-295

*Special order item only. Contact SECO-LARM for more details:

5 Separate zone inputs

N.O. or N.C. (selectable) instant zone with exit delay
N.C. instant zone with exit delay
N.C. delay zone with entry and exit delays
N.O. 24-hour panic zone with no entry and exit delays
N.C. 24-hour tamper zone instant trigger no delay

5 Zone shunting switches correspond to the 5 zone inputs. Shunt out any zone that is not working properly to prevent false alarms.
All inputs are super-high-transient protected.
3 Adjustable timers.

Entry delay timer adjustable from 1 sec to 45 sec.
Exit delay timer adjustable from 1 sec to 45 sec.
Alarm duration timer adjustable from 3 sec to 20 min.

9 Status LEDs.

(LEDs #1-5) Individual zone status green LEDs
Total zone status green LED. Indicates total zone status of the five zones
Arm/disarm/shunt status red LED. Indicates if alarm is armed, disarmed, or if a zone has been shunted
Entry/Exit status yellow LED. Indicates if alarm is in entry or exit delay mode
Primary power status red LED. Indicates if AC power is on or off
All 9 status LEDs visible when cabinet is closed

2 Alert signals for entry and exit delay.

Exit delay: A pulsed output during exit delay
Entry delay: A constant output during entry delay
Patented Automatic Extended Exit Delay (A.E.E.D.): Opening a switch/sensor connected to an exit delay zone before the exit delay elapses automatically extends the exit delay for as long as the switch/sensor remains open
Fail-safe circuitry: Alarm cannot be armed unless all switches and sensors connected to unshunted zones are in their non-violated state
Phase-II continual protection: To assure continuous protection, any input that remains triggered after the alarm duration has elapsed will shut down. All other inputs will remain armed
Multi-remote arm/disarm: Allows for the installation of up to 10 arming/disarming devices
Arm/disarm report output: Sends 100mA transistor ground signal to indicate alarm is armed or disarmed
Tamper output: Sends a 100mA transistor ground signal for as long as the tamper zone is activated
Dry relay contact panic output (C. - N.O.): Relay contacts close when the panic zone is activated
Positive voltage (3 Amp) relay alarm output: Powers signaling devices like a siren, bell, dialer, etc.
Works on 16V AC/DC with back-up battery input
Use with DC adapter or Class-II transformer
Regulated power supply and recharger
Heavy-duty, beige-colored steel cabinet: Measures 8¹/₂"x3¹/₈"x11⁷/₁₆" (215x79x290 mm)

Detachable front cover of steel cabinet
2 tamper switches included: Detects if steel cabinet front cover opened or cabinet removed from wall

Tags: